TFTP switch config upload from PC to standalone switch
I have done this before and for the life I can't figure it out. I need to upload a config via TFTP to a switch which is not networked.
I configured vlan 1 with IP address of 192.168.15.2 and configured a port on the switch to be a trunk port to allow vlan 1 and 15.
I statically assigned my PC with an IP address of 192.168.15.50 and default gateway of 192.168.15.1.
From the switch I can ping 192.168.15.2 but cannot ping 192.168.15.50.
From the PC I can telnet to 192.168.15.2 I thought all I had to do was to give the switch an ip address and assign a locally attached PC with a static address on the same network. Once I can get these to talk to each other the rest is easy
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...