Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

The strange trouble with C2950T

Hello all.

I have a trouble with WS-C2950T-24(121-19.EA1c). Sometimes, I see the log message:

: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/4, changed state to upSCHAN ERROR INTR: unit=0 SRC=6 DST=5

OPCODE=20 ERRCODE=5

SCHAN ERROR INTR: unit=0 SRC=6 DST=5

OPCODE=20 ERRCODE=5

SCHAN ERROR INTR: unit=0 SRC=6 DST=5

OPCODE=20 ERRCODE=5

after that I dont see the mac-address table from this device. What means this message?

1 REPLY
VIP Purple

Re: The strange trouble with C2950T

Hello,

you could be hitting the following bug:

CSCdv83336 Bug Details

Under certain level of traffic load, the switch will start logging the

following messages on the console:

SCHAN ERROR INTR: SRC=6 DST=5 OPCODE=20 ERRCODE=5

and after a few seconds, the switch will stop passing any traffic. In some

cases, the switch seemed still forwarding broadcast and multicast traffic,

which will cause STP problem if the switch has redundant link and is not

supposed to be the root for the VLAN, as both port will go forwarding.

The same error message has been identified in CSCdu87836.

An assessment of the impact

Unit stops passing any traffic.

WORKAROUND

Several units were returned by CISCO. The units were re-screened to the

latest test program, and failed the SDRAM memory test.

Customer should RMA unit back to Cisco.

HTH,

GP

175
Views
0
Helpful
1
Replies