Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

there is log channel-misconfig

Hi Expert

I facing log file form cisco switch like this

PM-4-ERR_DISABLE: channel-misconfig error detected on GiX/X, putting GiX/X in err-disable state

I've verify all config are match correctly. if I want to bypass checking

what difference between command

1. "no spanning-tree etherchannel guard misconfig"
2. "no error-disable detect cause channel-misconfig"

and how effect between 2 cli

from my research https://supportforums.cisco.com/thread/2173351 1. is feature of STP for detect misconfig


4 REPLIES
Cisco Employee

there is log channel-misconfig

The first command will disable the ether-channel guard misconfig on the switch.Yes, its used by STP for any misconfiguration, ideally the settings and port capabilities have to be identical on both the ports/sides.

The second command will disable the interface shutdown from channel-misconfig errors.

One will detect it and the other will put the ports in shutdown state so these two command go hand-in-hand.

-amit singh

New Member

there is log channel-misconfig

thankyou very much

please share document that explain this

Hall of Fame Super Gold

there is log channel-misconfig

PM-4-ERR_DISABLE: channel-misconfig error detected on GiX/X, putting GiX/X in err-disable state

This line is very specific.  It means that the port-channel configurations to some of your physical interface is inconsistent and the Cisco appliance, which can't read your mind to determine which one of the configuration you want, disables the port(s) until you fix the issue.

1. "no spanning-tree etherchannel guard misconfig"

2. "no error-disable detect cause channel-misconfig"

Using either one of these two will not be of any help.  You've got an inconsistent configuration.  Fix that.  Post the interface configuration of all the physical interface as well as the logical (port-channel) interface so we will be able to help you determine where the problem lies.

New Member

there is log channel-misconfig

Hi All

I've verify all configuration and physical are correct log occur since 1 week ago  there are no configuration change in port-channel in each device 

Topology like hub and spoke Hub device is Other vender spoke device are Cisco

log occur 1-2 time per day when auto-recovery work and port comup everything work fine

now I use  "no spanning-tree etherchannel guard misconfig" 

282
Views
0
Helpful
4
Replies
CreatePlease login to create content