I have three T1s that are bundled into interface multilink33, which have been working for years. It drop suddenly last week and I can't seem to get it to come back up again. I have verified that it's not a physical circuit problem. When I take the physical interface out of the multilink23 and remove encapsulation ppp, the interface comes up. When I add "encapsulation ppp" and add the interface back into multilink33, the interface goes down.
I've ran a #debug ppp multlink and it shows the physical inteface and virtual multilink33 flapping. Attached are the configuration for each router. Any assistance would be greatly appreicated. I owe you a beer!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.