Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

TinyRom error 800

When ever I save a config on this 800 series router I am getting this message.

WARNING: no valid "boot system" command. TinyROM will

pick an IOS image to boot.

If I view the flash I get;

0 ---- 49096 Nov 8 2000 03:37:53 +00:00 TinyROM-1.4(1)

1 -r-x 4836308 Jun 9 2004 02:32:27 +00:00 c800-y6-mw.123-5d.bin

Is this an error or something I should be concerned about?

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: TinyRom error 800

Hi,

I believe what the message is saying is that the default IOS rules will be used for determining which image is used to boot up the router.. Since you only have one image, it's not an issue but you can probably make the message go away by configuring the following:

boot system flash:c800-y6-mw.123-5d.bin

Hope that helps - pls rate the post if it does.

Paresh

2 REPLIES
Purple

Re: TinyRom error 800

Hi,

I believe what the message is saying is that the default IOS rules will be used for determining which image is used to boot up the router.. Since you only have one image, it's not an issue but you can probably make the message go away by configuring the following:

boot system flash:c800-y6-mw.123-5d.bin

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: TinyRom error 800

thanks Paresh, that indeed has got rid of the message,

Thanks

Rob

123
Views
0
Helpful
2
Replies
CreatePlease to create content