cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
301
Views
0
Helpful
3
Replies

To benefit of Multilink Frame Relay (FRF.16.1)

adriatikb
Level 1
Level 1

We have 4 E1 links with for 32 links 256 bits encapsulation frame relay. The links are point to point , each link have their DLCI and on router tha we have 4 E1 are 32 DLCI

To benefit of Multilink Frame Relay (FRF.16.1) what we can do?

Thanks.

1 Accepted Solution

Accepted Solutions

Please see the configuration examples in the manual:

http://cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087cbf.html

As an appreciation to those providing answers, remember to rate useful posts using the scrollbox below!

View solution in original post

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

The first and foremost benefit is that you can have, in the hub site, enough bandwidth to support the sum of access speed, and CIR, for all the branches, without worrying about splitting the branches in groups to map into a single link.

Also to consider, redundancy due to the multiple links, and efficiency compared to an ATM/FR solution, due to the much smaller overhead.

Hope this helps, please rate post if it does!

thank you !

can you give me an example of configuration that is needed

Please see the configuration examples in the manual:

http://cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087cbf.html

As an appreciation to those providing answers, remember to rate useful posts using the scrollbox below!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: