Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

track ip route COMMAND

Hi,

Can some one explain how this will work with change in metric. what does threshold mean here and how to configure threshold.

ROUTER(config)#track 1 ip route 2.2.2.2/32 metric threshold ?

<cr>

I cannot put threshold value here..

Thx,

G

1 REPLY
Bronze

Re: track ip route COMMAND

Hi gaurav,

The default up and down threshold values are 254 and 255, respectively. With these values, IP route threshold tracking gives the same result as IP route reachability tracking.

your command

track 1 ip route 2.2.2.2/32 metric threshold

Gives the default values mentioned above.

To set a metric threshold other than the default value, use the threshold metric command in tracking configuration mode. To disable the metric threshold, use the no form of this command.

threshold metric up number down number

no threshold metric up number down number

example:

track 1 ip route 10.22.0.0/16 metric threshold

threshold metric up 16 down 20

The metric default value is changed to 16 for the up threshold and to 20 for the down threshold.

Hope this helps you

Thanks

Raj

1445
Views
0
Helpful
1
Replies
CreatePlease to create content