I have a Cisco 819G router which I've setup to use ADSL on the Dialer0/Gigabit0 interface, and 3G on the Dialer2/Cellular0 interface. Both of these connections work without tracking. When I install tracking on the Dialer0/Gigabit0 interface the interface comes up, the route is installed, and it works well. However, when I implement the same configuration for the Dialer2/Cell0 interface, the interface doesn't come up on boot, and the route is not installed. I've tried adding the command "Default-state up" to the tracking configuration, and delay down 180 without luck. I've also trying using an EEM script to set the tracking as up after boot, but the default route still doesn't get installed in the routing table.
SLA statement 101 is for tracking statement 101, which is for Dialer0, which is attached to Gigabit0/ADSL service
SLA statement 102 is for tracking statement 102, which is for Dialer2, which is attached to Cell0/3G service
Current running configuration below, along with current output of show ip route, and show track 102. I can run any commands on this service you like. The ADSL service is currently unplugged as it's supporting the client's existing setup while we get this Cisco router right.
QUESTION: Is there a way to get reachability tracking to work successfully with a 3G service, if so, how?
Many thanks, and for any readers who find this helpful, please login and mark the authors posts as helpful.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.