Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Tracking ATM PVC

We are trying to identify a method where the ATM sub-interface shows line protocol UP but the ip reachability to the other side of the PVC is not there due to some issues in the ATM backbone.

Can we would be able to use the track 1 interface ip routing would help us . If so ,when it identifies the ip reachability on the PVC is done,will it log into the router or can it send to the management station. We are trying to deploy the same in 7600 switches running 12.2(18)SXF4.

Thanks

Regards

Anantha Subramanian Natarajan

4 REPLIES
Hall of Fame Super Gold

Re: Tracking ATM PVC

Hi Anasubra,

you could use the method of ATM OAM cell for continuity check. Please see:

http://cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080110bc4.html

Hope this helps, please rate all useful posts using the scrollbox below!

New Member

Re: Tracking ATM PVC

Hi ,

Thankyou very much . But I guess the link specifies that the same feature is integrated in 12.2(28)SB. So I guess, since our routers are running 12.2(18)SXF4, the same cannot be used. Is my understanding right ? If so, is there any other method, the same can be ensured .

Once again,Thanks

Regards

Anantha Subramanian Natarajan

Hall of Fame Super Gold

Re: Tracking ATM PVC

Hi,

12.2(x)SB is for Cisco 10000 routers. Please try if the command is available on your 7600, as the feature may or may not be have been ported.

An alternative to exact PVC tracking may be "IP SLA".

As a courtesy to those providing answers, please rate all useful posts using the scrollbox below!

New Member

Re: Tracking ATM PVC

Thank you

125
Views
4
Helpful
4
Replies
CreatePlease to create content