traffic-export command in cisco 880 series router

[sikusikanyika]

hi,

i am trying to enable packet capture using the instructions found at Router IP Traffic Export Packet Capture Enhancements. i have managed all the instructions except towards the end. when i type:

Router#traffic-export interface fasteth0/0 clear

              ^

% Invalid input detected at '^' marker.

The command doesn't seem to be availble in this mode.

the command: sh ver gives

Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 12.4(20)T5,

2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Mon 08-Mar-10 15:58 by prod_rel_team

ROM: System Bootstrap, Version 12.4(22r)YB5, RELEASE SOFTWARE (fc1)

any help to enable me proceed from here would be helpful.

thanks

[vmiller]

Restrictions for IP Traffic Export

Platform Restrictions

IP traffic export is intended only for software switching platforms; distributed architectures are not supported.

IP traffic capture is supported only on the Cisco 1841, Cisco 2800 series, and Cisco 3800 series integrated services routers.