Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

traffic graph and input rate do not much

I have mrtg which graphs cisco 10k router traffic input and output on interfaces. It graphs well except on 1 interface (POS). On this interface the input rate on sh int and on the graph don't much. There is around 120M on sh int and around 6 on graph, for example. Why is this? The output on this same interface muches on sh int and graph.

2 REPLIES

Re: traffic graph and input rate do not much

Hi Mulugeta

Whats the bandwidth configured under the pos interface ?

regds

New Member

Re: traffic graph and input rate do not much

it's an STM1, 155M

109
Views
0
Helpful
2
Replies