Hi Everyone. I have an older 2500 Series router that I use as a front end for a WAN link. I need to be able to monitor the traffic type, bandwidth usage on it and also I'd like to be able to graph bandwidth usage by destination address of all traffic crossing it... does anyone know of a tool that will assist me with this process? Can it be done through MRTG? If so, which method would you use to accomplish it?
What router would you recommend, has to support 100Mbps or close to it link, it is for our Microwave link, connects direct to radio (and then regular ethernet on the other side) which runs at roughly 94Mbps once you take the overhead into account... the older 2500 runs fine with it.
Yes, you are correct. I was incorrect in my logic on my network, confusing interfaces. I will be closing this topic but opening a new one. That one will focus on if I can make those measurements through a Catalyst 3548 or 3550 switch.
Thanks for all your input, sorry for the confusion.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.