i have a 6509 (version 12.2), and have some customers with static ip addresses. I need to mirroring the traffic from these customers and send to a hardware filter. Is using SPAN function the only way to do that?
I tried to do that on a BigIron layer3 switch. It's much eaiser to do that with the following configuration:
interface ether 5/15
ip policy route-map MAP1
match ip address 1
set mirror-port 5/12
ip access-list standard 1
permit ip host xx.xx.xx.xx
mirror-port ethe 5/12
Is there any way on Cisco platform similar to the BigIron solution? I have to do that on the cisco device because I have some customers connected to cisco, not through bigiron.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.