Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Traffic shaping issue with MLPPP

Hi all,

I am trying to enable traffic shaping over a Multilink consisting of 3 T1 serial interfaces. I have to configure shaping 90% of total bandwidth (4.5 Mbps). However, it gives me error message that shaping is restricted to individual serial link bandwidth.

Router(config-if)#service-policy output SHAPE-4.5M

%4050000 bps is greater than interface Serial1/1.1/1:0 rate (1536000 bps),

class 'class-default'

%4050000 bps is greater than interface Serial1/1.1/2:0 rate (1536000 bps),

class 'class-default'

%4050000 bps is greater than interface Serial1/1.1/3:0 rate (1536000 bps),

class 'class-default'

Is there an option to configure it? This is an OSM module on Cisco 7600 router.

Thanks,

Faad

1 REPLY
Hall of Fame Super Silver

Re: Traffic shaping issue with MLPPP

Hello Faad,

what IOS image is running on it?

there are some functional limitations on WAN modules for C7600 and C6500.

http://www.cisco.com/en/US/docs/routers/7600/install_config/12.2SR_OSM_config/qos.html#wp1052146

Hope to help

Giuseppe

299
Views
0
Helpful
1
Replies
CreatePlease to create content