Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

traffic shaping with bandwidth limitation

Dear Everybody,

I have to limit the 10 mbps bandwidth for IP base. like one IP use maximum 40 % and second one 40 % and rest of all are 20 %.

can we do traffic shapping while  limiting the bandwidth . please share configuration or any document with practical scenario

Thanks

1 REPLY

Re: traffic shaping with bandwidth limitation

your're beter off using CBWFQ  Instead of shaping without having to buffer any excess traffic.

CBWFQ is the MQC equivalent of a combination of the legacy interface level fair-queue command and the custom-queue. CBWFQ is used to reserve a minimum amount of bandwidth in the output queue for a particular traffic flow in the case of congestion.

see this for configuration examples http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcfwfq_ps1835_TSD_Products_Configuration_Guide_Chapter.html#wp1001889

Francisco

497
Views
0
Helpful
1
Replies
CreatePlease to create content