Under sh traffic-shape fastEthernet 0/0, the output is Target rate = 640000 (bps), Sustains bits/int = 40000 (bits), Internal 62ms and increment 5000 (bytes).
From my understand the total bandwidth allowed on the physical interface is 640Kbps. The sustains bits is the Burst committed which means what the router is only allowing the maximum traffic to be sent through the interface is 40000 bits every 62ms (Time committed). Can someone advise pls. I sometime confuse myself with the traffic shaping equation.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...