Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

translate tcp to x25

hio, I`ve a problem with my tcp to x25 conversation. my client works with tcp. it communites with a x25 server. I put a router to the networks witch makes the protocol translation.the tcp handshake works well, but after the handshake the router sends a 12 byte data pattern to the client. I think the datapattern are control data. The client has problem with this pattern and sends a reset to the client. Is it posible to supress this data packet with 12 byte lenght.

the configuration:

x29 inviteclear-time none

!

x29 profile POST 1:0 2:0 3:0 4:2 5:0 6:0 7:0 8:0 9:0 10:0

x25 routing

interface Serial1/0

no ip address

encapsulation x25

x25 address 46437055

x25 htc 5

x25 ips 256

x25 ops 256

x25 idle 5

serial restart-delay 0

lapb T1 1600

lapb N2 9

no clns route-cache

translate tcp 172.19.16.13 port 8054 x25 464113482 profile POST quiet swap

x25 route 464113482 interface Serial1/0

thanks for help

2 REPLIES
New Member

Re: translate tcp to x25

check out the following link for X.25 to TCP translation, see if it helps :

http://www.cisco.com/en/US/tech/tk713/tk730/technologies_configuration_example09186a0080094a46.shtml

New Member

Re: translate tcp to x25

I have the same problem. The X25 device don?t accept a call with "pad" pattern, and is impossible to modify the CUD.

Do you have an idea to resolve this?

Best regards.

Christian

189
Views
0
Helpful
2
Replies