01-23-2006 07:56 AM - edited 03-03-2019 11:32 AM
hio, I`ve a problem with my tcp to x25 conversation. my client works with tcp. it communites with a x25 server. I put a router to the networks witch makes the protocol translation.the tcp handshake works well, but after the handshake the router sends a 12 byte data pattern to the client. I think the datapattern are control data. The client has problem with this pattern and sends a reset to the client. Is it posible to supress this data packet with 12 byte lenght.
the configuration:
x29 inviteclear-time none
!
x29 profile POST 1:0 2:0 3:0 4:2 5:0 6:0 7:0 8:0 9:0 10:0
x25 routing
interface Serial1/0
no ip address
encapsulation x25
x25 address 46437055
x25 htc 5
x25 ips 256
x25 ops 256
x25 idle 5
serial restart-delay 0
lapb T1 1600
lapb N2 9
no clns route-cache
translate tcp 172.19.16.13 port 8054 x25 464113482 profile POST quiet swap
x25 route 464113482 interface Serial1/0
thanks for help
01-27-2006 03:01 PM
check out the following link for X.25 to TCP translation, see if it helps :
http://www.cisco.com/en/US/tech/tk713/tk730/technologies_configuration_example09186a0080094a46.shtml
09-08-2006 03:15 PM
I have the same problem. The X25 device don?t accept a call with "pad" pattern, and is impossible to modify the CUD.
Do you have an idea to resolve this?
Best regards.
Christian
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: