We want to transmit a power plant RTU data to another RTU over an Ip Network.This part of network is consist of two 1760 (with serial module) that are connected to each other by 3750switches that are connected through fastethernet ports by fiber optic.
Modem of this Rtu (ids wt850) claims that it converts fsk data to serial RS232 and says that supports HDLC on its port.
When i connect this output to 1760serial module the protocol does not get up and always is down .(line is up)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...