cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
257
Views
0
Helpful
1
Replies

Troubles with my link between switch and router

joana_magally
Level 1
Level 1

Hello I need your help I have connected a Router Cisco 7204VXR and a switch 2960-8 via fiber optic but the link is down these are my configurations:

Router:

!

interface GigabitEthernet0/2

no ip address

duplex auto

speed 1000

media-type sfp

no negotiation auto

!

Switch

!

interface GigabitEthernet0/1

switchport mode trunk

media-type sfp

speed nonegotiate

!

RTRCITYQ#show interfaces gigabitEthernet 0/2

GigabitEthernet0/2 is down, line protocol is down

  Hardware is MV64460 Internal MAC, address is 000a.f3ba.701a (bia 000a.f3ba.701a)

  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Half-duplex, 1000Mb/s, link type is force-up, media type is LX

On my SWITCH : Full-duplex, 1000Mb/s, link type is force-up, media type is LX

Can I help me?

Thanks

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

switchport mode trunk

media-type sfp

speed nonegotiate

Take this three lines off your switch first and observe.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card