Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Troubles with my link between switch and router

Hello I need your help I have connected a Router Cisco 7204VXR and a switch 2960-8 via fiber optic but the link is down these are my configurations:

Router:

!

interface GigabitEthernet0/2

no ip address

duplex auto

speed 1000

media-type sfp

no negotiation auto

!

Switch

!

interface GigabitEthernet0/1

switchport mode trunk

media-type sfp

speed nonegotiate

!

RTRCITYQ#show interfaces gigabitEthernet 0/2

GigabitEthernet0/2 is down, line protocol is down

  Hardware is MV64460 Internal MAC, address is 000a.f3ba.701a (bia 000a.f3ba.701a)

  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Half-duplex, 1000Mb/s, link type is force-up, media type is LX

On my SWITCH : Full-duplex, 1000Mb/s, link type is force-up, media type is LX

Can I help me?

Thanks

1 REPLY
Hall of Fame Super Gold

Re: Troubles with my link between switch and router

switchport mode trunk

media-type sfp

speed nonegotiate

Take this three lines off your switch first and observe.

127
Views
0
Helpful
1
Replies
CreatePlease login to create content