12-12-2006 10:41 AM - edited 03-03-2019 03:01 PM
Hi,
IOS: 12.4(5a)
I'm having problems with my 2FE2W. All 3 lights in the back for both ports 9when Connected) flash together (3 per port) on and off every 2-3 sec.
The status of the interface goes up and down every 2-3sec.
Tried the module in slot2 and slot3, same issue.
Swapped cables , no change.
All config is good and interface is no shut with Xover to PC. Tried a different PC, same issue.
How can I pinpoint what the issue is? Is it a router or a module issue?
Thanks
12-12-2006 07:03 PM
I guess you need to do some kinda of a trial-error method.. if you have another spare chassis, try putting the module in that and see if it works fine.. If it does not work on that too, it is clearly something to do with the module.. Also check for the IOS, if it supports this module on the present 3640.. there could be a software issue too !!!
hope this helps..all the best..
Raj
12-12-2006 09:59 PM
Agreed w/ Raj that the only item that you did not swap is the chassis & the module.
Try to source a chassis and another module and test again.
Did you try to set both speed and duplex to auto (and same speed & duplex) at both ends (router and connected device) and test again ?
Hope this helps.
12-13-2006 04:45 AM
Thanks all, will try this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: