Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

troubleshooting these E1s

Hi Experts

i have some branches connected over E1s Lines , now they are working properly,later on how to troubleshooting these E1s

thanks

jamil

5 REPLIES

troubleshooting these E1s

Jamil,

Like Paolo stated, there's really nothing to troubleshoot unless you're having an issue...which we all hope you never have

John

HTH, John *** Please rate all useful posts ***
Community Member

troubleshooting these E1s

Guys , but the encap is PPP

troubleshooting these E1s

If the circuit is up though, there's no need to troubleshoot anything if there aren't any problems. If you're just wanting to see if there are errors, you can do a "sh int " and look for frame or crc errors. If you have any errors like that, then clear counters and watch them over time. If they continue to increment, then you could have a problem with a cable to the demarc or a problem with the circuit itself.

HTH,

John

HTH, John *** Please rate all useful posts ***
Community Member

troubleshooting these E1s

Thanks John

Hall of Fame Super Gold

Re: troubleshooting these E1s

Ibrahim Jamil wrote:

Guys , but the encap is PPP

Encapsulation.doesn't matter. If it works before but not after, is telco fault.

Also, do not low rate posts that are 100% correct just because they don't suit you. That will only make so that professionals on this forum will know how to deal with your questions in the future.

To partially compensate, I've rated it again.

501
Views
16
Helpful
5
Replies
CreatePlease to create content