Troubleshooting WAN (FastE) interface "input errors"
I'm having trouble convincing my ISP that I'm having problems. I have a Cisco 1811 router with two WAN interfaces connected up to two different ISPs. One ISP connection (on my FastEthernet1 interface) is having no problems...and I'm seeing no errors on that interface. I'm having "slowness" problems on my other ISP ...here's a show int:
#show int faste0
FastEthernet0 is up, line protocol is up
Hardware is PQ3_TSEC, address is 001f.6c8f.8c3e (bia 001f.6c8f.8c3e)
Description: XXXX WAN Internet Internet address is x.x.x.x/29
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:23, output 00:00:05, output hang never
Last clearing of "show interface" counters 1d11h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
54569 packets input, 60095887 bytes
Received 6406 broadcasts, 0 runts, 0 giants, 0 throttles
0 output buffer failures, 0 output buffers swapped out
I've done everything *I* can do, I've swapped patch cables between the router and the ISP's media converter, I've swapped the ISPs between FastE0 and FastE1 (the input errors follow the "bad" ISP's connection)
I've changed speeds & duplex...that didn't fix it either... I'm still getting "input errors"
Is there anything I can do to find out more about these "input errors"... note that the CRC, frame, overrun, etc. counters don't go up at all... just these "input errors"
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.