12-15-2013 04:08 AM - edited 03-04-2019 09:51 PM
Hi all,
I have scenario I connected my Cisco 2960x-24Gig switch with a server hace 1000BaseT NIC and configure a switch port as a trunk with on mode...trunk is working but the trunking is at a-100 speed i didnt assign any any manual speed on either side both working on auto
12-15-2013 05:02 AM
On the 2960X, do the following commands:
1. Command: test cable tdr interface Gig
2. Wait for about 5 to 7 seconds;
3. Command: sh cable tdr interface Gig
4. Post the output to #3.
12-18-2013 01:50 AM
Solved using
interface GigabitEthernet1/0/11
switchport mode trunk
switchport nonegotiate
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: