Trunk from Switch 2960x Gog port to Server having 1000BaseT NIC but Trunk auto speed is a-100 why???
I have scenario I connected my Cisco 2960x-24Gig switch with a server hace 1000BaseT NIC and configure a switch port as a trunk with on mode...trunk is working but the trunking is at a-100 speed i didnt assign any any manual speed on either side both working on auto
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...