i have 2610xm router when i want to define the encapsulation on fastethernet 0/0.1 and 0/0.2 intefaces i didn't find the encpsuation command . and when i want to add ip address i have the following message :
% Configuring IP routing on a LAN subinterface is only allowed if that
subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q,
To add to above post, to download IP Plus version, you either need smartnet on your router, or atleast priviliged access to Cisco Software center (CCO Login) if you have smartnet on similar products. Or else you can buy the IP Plus IOS for a couple of 100 dollars.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...