Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trunking between Router 2612 and Switch 2950

I'm trying to trunk my Switch2950 to Router2612 Fastethernet interface, the encapsulation commands on the switch work, but when I try to

Int Fastethernet 0/0.1 on the Router

- there is no "encapsulation " command for each VLAN, The IOS is 12.2 ... it should be fine.

I'm trying to pass my CCNA and don't know why I'm not getting into the right config. If someone could help post something. Thanks.

1 REPLY
Hall of Fame Super Bronze

Re: Trunking between Router 2612 and Switch 2950

12.2?

You need 12.3 for 802.1q Vlan trunking in 2600 routers.

Please upgrade the code.

HTH,

__

Edison.

121
Views
0
Helpful
1
Replies
CreatePlease to create content