Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Trying to put a single static address on Dialer0

Hi. Our ISP (Pipex) has given us a single public IP address with a subnet mask of 255.255.255.255, and we're trying to set it on dialer 0.

Dialer0 is complaining about the subnet mask, is there any way around that?

Thanks

4 REPLIES
Hall of Fame Super Silver

Re: Trying to put a single static address on Dialer0

Huw

I am not sure what the issue is. Could you post a cut and paste of your attempt to configure the address on the dialer interface and the exact error that the router gives? This might give us better insight into the issue.

HTH

Rick

Silver

Re: Trying to put a single static address on Dialer0

try putting ' ip address negotiated '

then let ppp come up. follow that by show ip int brief.

Ajaz

New Member

Re: Trying to put a single static address on Dialer0

I think its OK now guys. Pipex have said that if I set my router to DHCP (using the ip address neg command) I should go and grab the same IP address from them each time.

Cheers all

Silver

Re: Trying to put a single static address on Dialer0

it ok mate anytime. oh btw thanks for rating the post.

Ajaz

231
Views
0
Helpful
4
Replies
CreatePlease to create content