Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Trying to upgrade 4506 IOS Image but failed...

Hi Experts,

I have tried to upgrade the new IOS Image of 4506 but failed.. well, the IOS image already tftp inside to this switch. What I have done is as below:

1) Tftp to the switch

2) boot system flash:(IOS Image.bin)

3) reload

But seems like after reload, the IOS is still the old one.

Where do I go missing?

Thanks in advanced.

2 REPLIES
Cisco Employee

Re: Trying to upgrade 4506 IOS Image but failed...

Hi Cindy,

Can you paste the output of "sh version" and "dir bootflash:"? Can you check if config reg value is set to 0x2102 from show version?

Regards,

Ankur

Community Member

Re: Trying to upgrade 4506 IOS Image but failed...

Thanks Ankur. The problem solved..

Got to go to bootup, rommon> , then I managed to do upgrade from there..

Thanks again for your reply. :)

240
Views
0
Helpful
2
Replies
CreatePlease to create content