Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

Tunnel transmit bandwidth 8000


Could anyone tell me why the Tunnel bandwidth send/recieve is set to 8000kbps?

I have a 20Mb circuit here and I would like the tunnel to be able to consume all of it. Is there a command to do this?

Tunnel0 is up, line protocol is up

Hardware is Tunnel

Description: IPSEC/GRE Tunnel to WH

Interface is unnumbered. Using address of FastEthernet1/1 (x.x.x.x)

MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,

reliability 255/255, txload 1/255, rxload 28/255

Encapsulation TUNNEL, loopback not set

Keepalive not set

Tunnel source x.x.x.x (FastEthernet1/1), destination x.x.x.x

Tunnel protocol/transport GRE/IP

Key disabled, sequencing disabled

Checksumming of packets disabled

Tunnel TTL 255

Fast tunneling enabled

Path MTU Discovery, ager 10 mins, min MTU 92, MTU 0, expires never

Tunnel transmit bandwidth 8000 (kbps)

Tunnel receive bandwidth 8000 (kbps)

Last input 00:00:03, output 00:00:25, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 5372

Queueing strategy: fifo

Output queue: 0/0 (size/max)

5 minute input rate 1000 bits/sec, 1 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

5607085 packets input, 1295617062 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

183454 packets output, 28171753 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

Any help rated.




Re: Tunnel transmit bandwidth 8000

Hi Gavin

You can define the same using tunnel bandwidth recieve/transmit command.

you can also verify the below link for more info..


CreatePlease to create content