Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Tunnel

*Mar 1 01:16:28.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up

*Mar 1 01:16:57.419: %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing

*Mar 1 01:16:58.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to down

I have this message constantly prompting on my scree... it indicating the tunnel protocol is down... but the other end of the tunnel is remain UP/UP... so what is the cause of this side tunnel interface flapping from up to down and up...?

regards

Devang

4 REPLIES

Re: Tunnel

its resolved now...

Cisco Employee

Re: Tunnel

The good old tunnel recursion problem ;-)

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

Re: Tunnel

Devang

I used to face the same problem in our MPLS when the GRE tunnel address was getting redistributed.

What was the problem in your case

Narayan

Re: Tunnel

132
Views
5
Helpful
4
Replies