I have two Cisco 1941 routers which will establish a site-to-site VPN between two locations. I'd like to test my configuration before deploying, so I thought it would be interesting to connect them to a 3750 and simulate the LAN/WAN environment, all contained within that 3750.
So, my thought process was pretty straightforward. I thought I would build 4 vlans (2 different "inside" networks, and 2 different "outside" networks). IP routing is enabled on the 3750, but it does not appear as if interVLAN routing is working.
Is my entire thought process flawed, here? This should work, right? The purpose of this test is to see if my IPSec config is set up correctly.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...