Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Two Default Routes FROM OSPF

Hello All

i need help in OSPF routing . My network is like this

I have my two core switches which runs OSPF with each other . One of mý core switch is connected with my MPLS provider and running OSPF with provider .Second core switch is connected with my juniper firewall with which i have connected my internet link.

Firewall's inside interface is running ospf with core switch . On same virtual router i have a tunnel interface (having different IP range from inside IP range ) from where i have a site2site tunnel from firewall to my hub location for backup and i have a default route on firewall from inside interface towards tunnel interface.

when i run sh ip route | i 0.0.0.0 command i can see that i am getting one default route from MPLS connection which is OK , now i want, my core switchs have second route towards firewall interface( tunnel interface ) with low priority so that in case of MPLS link goes down, it easly switchover. 

my client dono't want to use static route in core switches.

Everyone's tags (3)
1 REPLY
Hall of Fame Super Blue

Two Default Routes FROM OSPF

Duplicate post, please use the link to post answers into the other thread -

https://supportforums.cisco.com/thread/2261535?tstart=0

Jon

251
Views
0
Helpful
1
Replies