Two different public ip addresses NAT'd to the same inside address?
I am trying to find a way to have 2 different public ip's go to the same interface on a pix. BGP is not an option. The networks are from two completely seperate providers. I am just curious to know if i could do what is in the example below.
ip nat inside source static 10.10.10.1 22.214.171.124 extendable
ip nat inside source static 10.10.10.1 126.96.36.199 extendable
Re: Two different public ip addresses NAT'd to the same inside a
I am looking for a reduandancy solution. Inbound load-balancing isnt so important, just want a way to reach the pix using either t1 for access incase one of the T1 goes down. Maybe setup a round-robin dns for both ip addresses and setup the vpn client with a hostname instead of an ip address.
Looking for any solution that doesnt require BGP or more hardware.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...