Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Two Subnet natting in Dmz

Hi, DMZ address is 200.200.200.0 subnet. What is the meaning to write 192.168.1.0 in DMZ, please help.

global (outside) 10 100.100.100.198 netmask 255.255.255.192

global (dmz01) 10 interface

nat (inside) 10 0.0.0.0 0.0.0.0 0 0

nat (dmz01) 10 200.200.200.0 255.255.255.192 0 0

nat (dmz01) 10 192.168.1.0 255.255.255.0 0 0

1 REPLY

Re: Two Subnet natting in Dmz

Any device from the dmz01 interface with the source IP address of 192.168.1.0 /24 would be NAT'd. I could see this being relative if you have VPN/remote users off that dmz. For example a VPN device on the 10.200.200.0 subnet and it hands out 192.168.1.0 addresses to the VPN users.

Hope that helps.

101
Views
0
Helpful
1
Replies