Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Two tunnels pointing to one loopback IP address

We recently had an issue with a routing configuration running EIGRP with 2 tunnels pointing to the same loopback IP. The router went down due a power outage and failover didn't work. Is it possible to have 2 tunnels point to the same loopback, if not, would that cause the failover not to work properly?

1 REPLY
New Member

Re: Two tunnels pointing to one loopback IP address

Hi,  Could you please attach some kind of topology diagram and any configs you are able to share as well as your explaination doesn't entirely give the whole picture for anyone to help you with.  Cheers, Joe

Posted from my mobile device.

151
Views
0
Helpful
1
Replies