cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
738
Views
0
Helpful
4
Replies

TXload is 255/255 with simple ping Traffic

Desmond Smith
Level 1
Level 1

I have Multilink setup with 2 combined T1 circuits, one at Site A and one at Site B.

When I perform a simple ping from site A to site B the ping is fine and the TXload and RXload are normal.

When I perform a simple ping from Site B to site A the TXload is 255/255 on a Multilink interface that is two T1's combined.

Any ideas on why the TXload is showing fully saturated (255/255) even though i am performing a simple ping?

Thanks,

Desmond

4 Replies 4

bkirby
Level 1
Level 1

Post your show int output for that interface

Sent from Cisco Technical Support iPad App

Leon
Level 1
Level 1

Any error on the T1 card?

Sent from Cisco Technical Support iPhone App

Nagendra Kumar Nainar
Cisco Employee
Cisco Employee

What is the box and version?

Recently I remember seeing a similar issue.

-Nagendra

Leon
Level 1
Level 1

what is the transfer rate when you pinging ?? is it  3 Mbps + ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco