We have layer 2 connectivity from our main office to an offsite facility where our servers reside. We are connected via fiber but is not a dedicated circuit.
Recently I created a VLAN with same ID on both switches (main office and Offsite facility) . I trunked the port on both ends but not traffic passes on this VLAN. Obviously only VLAN 1 works. According to a consultant the provider of the fiber connection needs to turn "something" on for us to be able to pass VLAN traffic other than VLAN 1's. What would be that "something", he does not even kow it himself.
Can anybody shed any light on this?. We are urgently needing to have a separate VLAN for our VOIP traffic.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...