Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Unable to log in to routers remotely

I am able to log in to my routers from LAN-

However when i vpn, I am unable to get even a response from a branch router. I can log into other routers at different sites. For some reason though, I get no response from the 4 IP addresses configured on the

interfaces for this particular router

I am able to log into a switch that is direclty connected to it-

And i attempt to telnet through that switch, but i get a "password,required but not set" response. I do have username/pw and login local configured on the vty lines.

does this make sense?

2 REPLIES

Re: Unable to log in to routers remotely

HI, [PLS RATE if HELPS]

Refer Link below for Help:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_example09186a0080202614.shtml

Kindly check whether you have followed the procedure as said in above link in configuring the password for Telnet Users.

PLS RATE if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Unable to log in to routers remotely

i have configured

username xxxx privilege 1 password xxxx

enable password xxxx

.

.

.

.

line vty 0 4

login local

any ideas?

208
Views
0
Helpful
2
Replies
CreatePlease to create content