Currently Head office and Branch office is connected through VSAT. We need to connect both Head office and Branch office through DSL instead of VSAT. We don?t need Load Balancing because DSL will replace VSAT.
Both Head Office and Branch is connected through VSAT and they are working fine. Now it needs to be connected on DSL instead of VSAT. But on DSL both machines are not able to reach each other. Branch office Server is able to Ping Head Office Layer 3 Switch interface G0/4 but it is not able to Ping Port1 IP address which is 10.20.0.2/24. Same as Head Office server is able to Ping Head office switch interface G0/17 and also GRE Tunnel Interface which is 10.50.0.2/24 but not able to Ping the other interface of Tunnel which is 10.50.0.1/24 and also Router F0/3/0 interface. We have checked on the firewall ICMP and Ping service is enabled in both direction.
We attached a Machine directly to the Head office Switch to check the connectivity in this case the Machine is able to Ping the Router F0/1 interface but the Branch Router is not able to Ping the Machine which is directly attached to the Head office switch.
Attached is the configuration and Network Diagram of Head office Switch and Branch office Router.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...