Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

unable to ping remote site components; 6500 switch L2 Ethernet 100 mbps VPN

Hi,

I use 6500 switch for VPN. That works fine. I use 3750 in a main office and 3550 in the remote office. Main office works on 192.168.11.0/24 and the remote VPN network works on 172.22.100.0/24.

Unable to ping from 192.168.11.0/24 network to 172.22.100.0/24.

How do i start troubleshooting the issue. I also attached the 3750 and 3550 show run-config. The Arp table also shows incomplete. Please i need help on this.

Thank you,

2 REPLIES

Re: unable to ping remote site components; 6500 switch L2 Ethern

I think you opened a duplicate thread.

Internet 172.22.100.34 0 Incomplete ARPA

what is the default gateway of that machine?

Please remember to rate useful posts, by clicking on the stars below.

New Member

Re: unable to ping remote site components; 6500 switch L2 Ethern

It seems 192.168.11.1. Is that not correct? do I need to configure the different route for the 172.22.100.0/24 network? How can I do that?

Thank you,

146
Views
0
Helpful
2
Replies
CreatePlease to create content