Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

unhash RV220W password for built-in cisco credential

hmm.. odd.

we have 4 RV220W routers installed in a mesh and all seem to be working fine.

oddly, one is configured just a bit differently.  instead of access via the 'cisco' credential, we have been using an added 'admin' credential.

no real issue so far except that now we find that SNMPv3 is not working for it on this RV220W router.

I'd like to re-set the default built-in 'cisco' credential but only know the 'admin' credential password.

Since we have the configuration file we should be able to un-hash the 'cisco' password and set it to something new, right?

Any clues on how simply un-hash that password (besides totally re-setting the router)?

 

ADVthanksANCE,

michael grimes

 

Firmware Version 1.0.4.17
Serial Number SER164602CM
Users 1/3
 

 

ciscoSSLVPNAdministratorLocal User DatabaseDisconnected 
guestSSLVPNGuestLocal User DatabaseDisconnected 
adminSSLVPNAdministratorLocal User DatabaseConnected

 

...

SSLVPNUser[1] = {}...

SSLVPNUser[1]["LoginFromBrowser"] = "0"
SSLVPNUser[1]["DenyLogin"] = "0"
SSLVPNUser[1]["DefaultUser"] = "1"
SSLVPNUser[1]["LastName"] = "ssl"
SSLVPNUser[1]["LoginFromIP"] = "0"
SSLVPNUser[1]["FirstName"] = "cisco"
SSLVPNUser[1]["UserType"] = "3"
SSLVPNUser[1]["Password"] = "10DB74166DC148DD8B8AA7E337D3D9B19F*"
SSLVPNUser[1]["UserName"] = "cisco"
SSLVPNUser[1]["GroupName"] = "SSLVPN"
SSLVPNUser[1]["UserTimeOut"] = "10"
SSLVPNUser[1]["_ROWID_"] = "1"
SSLVPNUser[1]["DenyLoginFromWan"] = "0"

 

 

27
Views
0
Helpful
0
Replies