Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unknown Protocol Drops

Has anyone ever seen this? In the output of a "show interface g0/0" on my 3825 router I am seeing a lot of "unknown protocol drops". Oddly enough it is the same number of broadcasts. This is causing an off-site location to record 13 percent loss.

2 REPLIES

Re: Unknown Protocol Drops

Hi,

I guess you are using IOS 12.4-7x or anything higher than 12.4-13x

This line is not available in 12.4-13x. not sure which releases this line started.

I did see this in 3800 series FE interface connecting to WAN but after thorough investigation I couldn't find what causing it. Wireshark didn't show what causing it. I don't experience any problem though.

Yes, they accumulate the same number as broadcast.

Regards,

Dandy

New Member

Re: Unknown Protocol Drops

Yes, this is the IOS Release we are running. "Cisco IOS Software, 3800 Software (C3825-ADVENTERPRISEK9_SNA-M), Version 12.4(19), RELEASE SOFTWARE (fc1)". It is the outside interface to a WAN link which we tunnel through to our main site.

243
Views
0
Helpful
2
Replies