Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Untagged VLAN on Trunk Port - help please

Hi folks.

I need to configure a port on a 3750E to support the following:

The port will connect to an Outreach Quad switch, and on the switch I will have 1 x 1130 LAP and on IP device. The Outereach switch is apparantly invisible to VLANS, and will forward both tagged and untagged traffic.

I need the port on the 3759 to accept traffic from the AP and allocate it to one VLAN and allocat the other IP device to another VLAN.

I am looking at sub interfaces (  the 3750 does not support them, i don't thnk) or SVI, or some other methid.

Please would anyone help and advise.

Many thanks,

NM

1 REPLY
Hall of Fame Super Silver

Re: Untagged VLAN on Trunk Port - help please

Hello Neil,

unless the IP device can be configured to use a vlan tag (for example this happens wit VMware instances) both devices will be in the native vlan.

you cannot use subinterfaces on the C3750 so probably your only way to accomodate IP addresses in two different IP subnets is to use ip address secondary under an SVI interface

interface vlan 1

ip address 10.10.10.1 255.255.255.0

ip address 10.10.20.1 255.255.255.0 secondary

this can do the trick

Hope to help

Giuseppe

Cisco will donate $1 to  the Red Cross Haiti fund for every rated post!

https://supportforums.cisco.com/docs/DOC-8727

1306
Views
0
Helpful
1
Replies
CreatePlease login to create content