Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

update the datasheets

Hello,

I have been searching the cisco website for data on the ISR routers.

Specifically I need the power consumption for the ISR 1941 and the ISR 2951

I was able to find similar info for the ISR 3945 and other ISR models at :

http://www.cisco.com/en/US/prod/collateral/routers/ps10536/data_sheet_c78_553924.html

But this does not include the models I am looking for.

Also, I looking for the "Maximum 3DES Throughput" for the models ISR 1941 and ISR 2951

Again, I was able to find a page which gave this info for other models in the series at :

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps7180/prod_brochure09186a00801f0a72_ns710_Networking_Solutions_Brochure.html

But not the ones I am looking.

Can you tell me this information ?

Or can you send me a link where I might find it ?

Many thanks for your help.

Re

Joe

  • WAN Routing and Switching
3 REPLIES
Hall of Fame Super Blue

Re: update the datasheets

Joe

I cannot find the information at the moment either. However as luck would have it there is an Ask the Expert on ISR G2 routers that continues until 11th December going on at the moment in this very forum so i suggest you post in there

https://supportforums.cisco.com/message/1323809#1323809

Jon

New Member

Re: update the datasheets

Hi Jon,

Thanks for the suggestion.

I have just posted the same question on the link you gave.

Many thanks,

Joe

Hall of Fame Super Blue

Re: update the datasheets

Joe

It may be a bug in the new site but you don't seem to have posted it into that thread, you have just posted it twice more into the WAN Routing and Switching forum.

Jon

186
Views
0
Helpful
3
Replies
This widget could not be displayed.