Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade FPD on NPE-G2 - Router can't boot up

Hi Sir,

I have upgraded a Cisco 7206VXR router from NPE-400 to NPE-G2.

Below are the actions I performed:

(1) Power off the router. Replace NPE-400 with NPE-G2. Power up router.

(2) Upgrade IOS to version 12.4(4)XD7. Image filename is c7200p-advipservicesk9-mz.124-4.XD7.bin

(3) Reboot router. IOS upgrade verified okay.

(4) Proceed to manually upgrade the FPD. Image filename is c7200p-fpd-pkg.124-4.XD7.pkg

(5) Power cycle the router and it is not able to boot. It stops at:

System Bootstrap, Version 12.4(4r)XD3, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 2006 by cisco Systems, Inc.

Socket jumper: not present Failsafe jumper: present = normal

FPGA revision 0x00000026

Before I upgraded the FPD, I did "sh hw-module all fpd". It showed current version is 0.36 and min. required version is 0.1. Despite this, I proceeded to upgrade the FPD. However, the router is not able to boot now.

I followed the following technote to perform the FPD upgrade:

http://www.cisco.com/en/US/products/ps6706/products_feature_guide09186a0080678b1d.html

Attached is console logs of the FPD upgrade.

Please help.

Thank you.

B.Rgds,

Lim TS

1 REPLY

Re: Upgrade FPD on NPE-G2 - Router can't boot up

Hi

I don't know if this is related, but this field notice came out the other day

http://www.cisco.com/warp/customer/770/fn62535.shtml

213
Views
0
Helpful
1
Replies