I've got a nice Cisco 2651XM router which I need to upgrade the flash memory in (have a new, bigger IOS to load). The 2651XM has an onboard 16MB and an empty onboard SIMM slot, so I brought a compatible (I hope) flash SIMM and installed it following the Cisco guide, but it dosnt show.
Doing a "show flash" tells me I have "16384K bytes of processor board System flash (Read/Write)" with or without the new SIMM installed. Is there somewhere I need to enable the new SIMM slot?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.