Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

uplink bandwidth using ios cli

Hi all,

How can i check from router the usage of our wan link  in terms of Mbps .

snmp monitoring can give statistics of traffic flowing through the pipe . but i want to check via CLI.

Netflow samples the traffic and dumps it on netflow server. Any kind of traffic metring can i use , may MQC ?

SHOW IP TRAFFIC shows just the packet counters .

thanks

1 REPLY
Hall of Fame Super Gold

uplink bandwidth using ios cli

Kindly post the output to the command "sh interface ".

197
Views
0
Helpful
1
Replies