Hi, I created a policy based route to take my server vlan and direct it to internet to a seperate T1. I wanted to separate workstation internet connection from the server internet connection. However I tested my link speed after configuring PBR, and my upload speed decreased drastically from 1.4Mbps to 700Kbps. The download speed did not change. I checked to see if there is any heavy traffic but there is almost no traffic on that link. Can simple PBR slow down the upload speed so much? Also when I remove the PBR the upload speed goes back to 1.4Mbps. I am using 2851 router which I believe should handle the PBR without any issues.
here is the config
route-map Server permit 10
match ip address 101
set ip next-hop x.x.x.x
access-list 101 deny ip 172.21.19.0 0.0.0.255 172.22.19.0 0.0.0.255
access-list 101 deny ip 172.21.19.0 0.0.0.255 10.0.0.0 0.0.0.255
access-list 101 permit ip 172.21.19.0 0.0.0.255 any
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...